- ページ 8

ドリル Bosch 11316EVS - SDS Max Demolition Hammer 14A MotorのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor 33 ページ。 Bosch demolition hammer parts list
Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor にも: クイック・リファレンス・マニュアル (25 ページ), 取扱説明書 (29 ページ), パーツリスト (2 ページ), 運営情報 (3 ページ), 取扱説明書 (33 ページ)

Bosch 11316EVS - SDS Max Demolition Hammer 14A Motor 取扱説明書
2610048701.qxp_DH712VC 10/5/17 8:01 AM Page 8
AUXILIARY HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen the
lock knob, move the handle to the desired
position along the barrel and securely retighten
the lock knob (Fig. 2).
INSTALLING ACCESSORIES
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the tool holder through
the dust shield, while twisting and pushing
inward until it locks automatically into place.
Pull outward on the accessory to be certain it is
locked into the tool holder (Fig. 3).
NOTE: The high efficiency available from the
hammers can only be obtained if sharp and
undamaged accessories are used. The "cost"
FIG. 3
3
TRIGGER "ON-OFF" SWITCH
Your tool is equipped with a "Lock-ON" feature
which allows continuous operation without
holding the trigger.
TO LOCK TOOL "ON":squeeze the trigger
switch until it locks (Fig. 5).
TO TURN TOOL: "OFF" press the trigger
release switch and the trigger will return to the
"OFF" position automatically (Fig. 5).
Assembly
5
4
DUST SHIELD
Operating Instructions
FIG. 2
1
LOCK KNOB
to
maintain
sharp
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING ACCESSORIES
Accessories may be hot
after use. Avoid contact
with skin and use proper protective gloves or
cloth to remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 4).
FIG. 4
2
To increase switch life, do not turn switch on
and off while tool is under load.
TRIGGER
SWITCH
RELEASE SWITCH
-8-
AUXILIARY
HANDLE
and
undamaged
1
LOCKING
SLEEVE
TRIGGER
FIG. 5