Andover Controls EMX34/CK34 Installationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationshandbuch für Computer Hardware Andover Controls EMX34/CK34 herunter. Andover Controls EMX34/CK34 12 Seiten. Cardkey interface board

Seite drucken

Wiring the EMX34 to an ACX Controller

1. Locate the Wiegand outputs, along the left-hand side of the EMX 34 printed circuit

board (P3, P5, P7 P9). Each output includes five connections.

Note that on the REV A board, the 1 and Ø terminals are labeled incorrectly.

Wiring the EMX 34 to an ACX 700/780

ACX 700/780

2. Strip the end of an 18 AWG wire. Insert it into the appropriate terminal block connector

according to the diagram and tighten the screw.

3. Repeat this procedure for the remaining four wires.

Wiring AC Power to the EMX 34

1. Locate the terminal labeled P1 in the upper left-hand corner of the printed circuit board.

2. Connect the stripped ends of a 24 VAC (±20%) external power supply to the

appropriate terminals and tighten the screws.

Should you need to replace the 1 amp socket picofuse, it is located at F1 on the printed

circuit board.

Technical Manuals Online! - http://www.tech-man.com

+5V

LED

1/DATA

0/CLK

GND

EMX 34

5VDC

LED

∅

(1 on rev A)

1 (∅ on rev A)

GND

EMX 34 Installation Guide