Andover Controls EMX34/CK34 Manuale di installazione - Pagina 8
Sfoglia online o scarica il pdf Manuale di installazione per Hardware del computer Andover Controls EMX34/CK34. Andover Controls EMX34/CK34 12. Cardkey interface board
Stampa la paginaWiring the EMX34 to an ACX Controller
1. Locate the Wiegand outputs, along the left-hand side of the EMX 34 printed circuit
board (P3, P5, P7 P9). Each output includes five connections.
Note that on the REV A board, the 1 and Ø terminals are labeled incorrectly.
Wiring the EMX 34 to an ACX 700/780
ACX 700/780
2. Strip the end of an 18 AWG wire. Insert it into the appropriate terminal block connector
according to the diagram and tighten the screw.
3. Repeat this procedure for the remaining four wires.
Wiring AC Power to the EMX 34
1. Locate the terminal labeled P1 in the upper left-hand corner of the printed circuit board.
2. Connect the stripped ends of a 24 VAC (±20%) external power supply to the
appropriate terminals and tighten the screws.
Should you need to replace the 1 amp socket picofuse, it is located at F1 on the printed
circuit board.
Technical Manuals Online! - http://www.tech-man.com
+5V
LED
1/DATA
0/CLK
GND
EMX 34
5VDC
LED
∅
(1 on rev A)
1 (∅ on rev A)
GND
EMX 34 Installation Guide
8