Electrolux AEG DD9663-M Betriebs- und Installationsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebs- und Installationsanleitung für Lüftungshaube Electrolux AEG DD9663-M herunter. Electrolux AEG DD9663-M 17 Seiten.

Seite drucken

Wall drilling and bracket fixing

Wall marking:

• Draw a vertical line on the supporting wall up to the

ceiling, or as high as practical, at the centre of the

area in which the hood will be installed.

• Draw a horizontal line at 650 mm above the hob.

• Place bracket 7.2.1 on the wall as shown about 1-2

mm from the ceiling or upper limit align-ing the centre

(notch) with the vertical reference line.

• Mark the wall at the centres of the holes in the

bracket.

• Place bracket 7.2.1 on the wall as shown at X mm

below the first bracket (X = height of the upper

chimney section supplied), aligning the centre (notch)

with the vertical line.

• Mark the wall at the centres of the holes in the

bracket.

• Mark a reference point as indicated at 122 mm from

the vertical reference line and 280 mm above the

horizontal reference line.

• Repeat this operation on the other side.

• Drill ø 8 mm holes at all the centre points marked.

• Fix the lower bracket 7.2.1 using the screws.

• Fix the upper bracket 7.2.1 and the air outlet con-

nection support 7.3 together using 2 screws.

• Insert the two screws in the hood body fixing holes,

leaving a gap of 5-6 mm between the wall and the

head of the screw.

INSTALLATION INSTRUCTIONS

��