Atlantic Ultraviolet Sanidyne 40-0674B Installation, Betrieb und Wartung - Seite 14
Blättern Sie online oder laden Sie pdf Installation, Betrieb und Wartung für Zubehör Atlantic Ultraviolet Sanidyne 40-0674B herunter. Atlantic Ultraviolet Sanidyne 40-0674B 20 Seiten. Germicidal ultraviolet portable area sanitizer
Seite drucken
MAINTENANCE
IN ORDER TO PERFORM THIS TASK, WEAR PERSONAL PROTECTION EQUIPMENT; GLOVES,
LONG SLEEVE SHIRT WITH NO GAPS BETWEEN CUFFS AND GLOVES, AND AN ULTRAVIOLET
BLOCKING FACE SHIELD MUST BE WORN TO COVER AND PROTECT EYES AND EXPOSED SKIN.
Always disconnect power to the fixture before performing any service or maintenance.
• A regular cycle of cleaning each STER-L-RAY
experience. The frequency of cleaning will vary with the conditions surrounding each installation. It is recommended that the
germicidal lamp(s) and Sanidyne
• The STER-L-RAY
®
average effective life of 13,000 hours. STER-L-RAY
reduction in ultraviolet output will make it impractical to use past the manufacturer's rated life. For maximum efficiency lamp
replacement is recommended every 13,000 hours of operation.
• Unless lamp replacement is due to failure or breakage, it is recommended that all lamps be replaced at the same time.
• It is recommended that the user maintain a log of all maintenance performed on Sanidyne
g
l
ermiCiDal
amP
IN ORDER TO PERFORM THIS TASK, WEAR PERSONAL PROTECTION EQUIPMENT; GLOVES,
LONG SLEEVE SHIRT WITH NO GAPS BETWEEN CUFFS AND GLOVES, AND AN ULTRAVIOLET
BLOCKING FACE SHIELD MUST BE WORN TO COVER AND PROTECT EYES AND EXPOSED SKIN.
NOTE: STER-L-RAY
protective covering over the glass of the lamp — DO NOT REMOVE this covering.)
Always disconnect power, to the fixture before performing any service or maintenance.
Germicidal lamps are easily damaged. Exercise care when handling lamps.
1.
To remove lamps follow the steps under "Lamp Installation" on Pages 9–10 in reverse order.
2.
Moisten a clean, lint-free cloth with denatured alcohol and wipe down the outer surface of the lamp.
3.
When lamp has been removed and cleaned, then safely set aside, remove any loose dust or dirt from the surface of the fixture
with a soft, dry cloth or vacuum.
4.
To reinstall lamps follow the steps under "Lamp Installation" on Pages 9–10.
5.
Reconnect Sanidyne
Avoid exposure to direct or strongly reflected germicidal ultraviolet rays.
Germicidal ultraviolet rays are harmful to the eyes and skin.
l
B
amP
reaKage
Broken Quartz is SHARP.
D
m
isPosal of
erCury
Germicidal ultraviolet lamps, like standard fluorescent lamps contain small amounts of mercury. Mercury added
lamps should not be placed in the trash. Dispose of properly. For further information regarding the disposal and
recycling of lamps containing mercury, along with Federal and State requirements visit LampRecycle.org. For more
information on STER-L-RAY
14
Prime Remote surfaces be cleaned at least once every three (3) months.
®
Germicidal Lamp(s) used in the Sanidyne
Personal protection equipment, such as gloves; long sleeves with no gaps between cuffs and gloves,
and an ultraviolet resistant face shield, is required when entering the irradiated space.
i
, r
nstallation
ePlaCement
lamps used in the Sanidyne
®
Prime Remote to utility power, and restart.
®
Wear protective gloves when handling broken ultraviolet lamps. In the event of breakage, DO NOT
use a household vacuum cleaner to pick up fragments of the lamp. Sweep up debris into a plastic
bag and dispose of in accordance with local and /or state regulations.
a
l
DDeD
amPs
Germicidal Ultraviolet Lamps, visit Ultraviolet.com or BuyUltraviolet.com.
®
Germicidal Lamp MUST be established based on visual inspection and
®
Prime Remote fixture have a manufacturer's rated
®
lamps may operate longer than their rated effective life, but the
®
,
C
or
leaning
Prime Remote have ArmorLite
®
Prime Remote. (See Page 17.)
®
Safety Shield (which is a
TM