Electrolux U312940. EFC70710 Benutzerhandbuch - Seite 20

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Lüftungshaube Electrolux U312940. EFC70710 herunter. Electrolux U312940. EFC70710 28 Seiten. Electrolux cooker hood usual manual
Auch für Electrolux U312940. EFC70710: Eigenschaften (7 seiten)

Seite drucken
Electrolux U312940. EFC70710 Benutzerhandbuch
20 electrolux
Fitting the Wall Brackets
Wall marking:
• Draw a vertical line on the supporting
wall up to the ceiling, or as high as
practical, at the centre of the area in
EN
which the hood will be installed.
• Draw a horizontal line at 650 mm
above the hob.
• Place bracket 7.2.1 on the wall as
shown about 1-2 mm from the ceiling
or upper limit aligning the centre
(notch) with the vertical reference line.
• Mark the wall at the centres of the
holes in the bracket.
• Place bracket 7.2.1 on the wall as
shown at X mm below the fi rst bracket
(X = height of the upper chimney
section supplied), aligning the centre
(notch) with the vertical line.
• Mark the wall at the centres of the
holes in the bracket.
• Mark a reference point as indicated
at 116 mm from the vertical reference
line and 306 mm above the horizontal
reference line.
INSTALLING THE COOKER HOOD
• Repeat this operation on the other
side.
• Drill ø 8 mm holes at all the centre
points marked.
• Insert the wall plugs (not supplied) in
the holes.
• Fix the lower bracket 7.2.1 using the
two screws (not supplied).
• Fix the upper bracket 7.2.1 and the air
outlet connection support 7.3 together
using the two screws (not supplied).
• Insert the two screws (not supplied)
supplied in the hood body fi xing holes,
leaving a gap of 5-6 mm between the
wall and the head of the screw.
Note: If the hood is to be installed
onto a hollow construction or
plaster or partition board wall
then special fi xing screws will be
required (not supplied).