Electrolux U312940. EFC70710 Посібник користувача - Сторінка 20

Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка Electrolux U312940. EFC70710. Electrolux U312940. EFC70710 28 сторінок. Electrolux cooker hood usual manual
Також для Electrolux U312940. EFC70710: Особливості (7 сторінок)

Друкувати сторінку

Electrolux U312940. EFC70710 Посібник користувача

20 electrolux

Fitting the Wall Brackets

Wall marking:

• Draw a vertical line on the supporting

wall up to the ceiling, or as high as

practical, at the centre of the area in

which the hood will be installed.

• Draw a horizontal line at 650 mm

above the hob.

• Place bracket 7.2.1 on the wall as

shown about 1-2 mm from the ceiling

or upper limit aligning the centre

(notch) with the vertical reference line.

• Mark the wall at the centres of the

holes in the bracket.

• Place bracket 7.2.1 on the wall as

shown at X mm below the ﬁ rst bracket

(X = height of the upper chimney

section supplied), aligning the centre

(notch) with the vertical line.

• Mark the wall at the centres of the

holes in the bracket.

• Mark a reference point as indicated

at 116 mm from the vertical reference

line and 306 mm above the horizontal

reference line.

INSTALLING THE COOKER HOOD

• Repeat this operation on the other

side.

• Drill ø 8 mm holes at all the centre

points marked.

• Insert the wall plugs (not supplied) in

the holes.

• Fix the lower bracket 7.2.1 using the

two screws (not supplied).

• Fix the upper bracket 7.2.1 and the air

outlet connection support 7.3 together

using the two screws (not supplied).

• Insert the two screws (not supplied)

supplied in the hood body ﬁ xing holes,

leaving a gap of 5-6 mm between the

wall and the head of the screw.

Note: If the hood is to be installed

onto a hollow construction or

plaster or partition board wall

then special ﬁ xing screws will be

required (not supplied).