Electrolux # Benutzerhandbuch - Seite 7

Caring for your vacuum cleaner

Turn off vacuum cleaner and unplug power cord. Motor

shaft and belt pulley can become hot with normal use.

Do not touch motor shaft when checking brush roll.

How to clear blockage

Remove Quick Release handle and hose.

Remove wand from handle. Twist bottom end of hose

to remove from vacuum cleaner body (Fig. 1).

Flex hose to loosen obstruction.

Use fingers to check for debris in bottom of unit (Fig. 2).

To replace hose, align tabs, push in and twist until it

locks.

Reattach wand; return handle to position on vacuum.

To clear inlet hose: Lay vacuum face down. Remove 5

screws (Fig. 4); lift off brush roll cover (Fig. 5). Clear

blockage from base hose (Fig. 3). Clear debris from

brush roll. Replace cover and 5 screws.

To remove brush roll

If belt pulley is hot due to recent use, allow to cool

before proceeding.

Press handle release with foot to lower handle

flat onto floor.

Lay vacuum face down; remove 5 screws (Fig. 4).

Lift off brush roll cover (Fig. 5)

Lift end of brush roll farther from belt (Fig. 6).

Lift other end and slip brush roll out of belt.

To replace brush roll or belt

Place belt onto motor pulley.

Thread brush roll into belt so belt fits into grooves;

align so end cap fits into square opening (Fig. 7).

Secure opposite end of brush roll.

Rotate brush roll two turns to center belt.

Replace brush roll cover and five screws.

To clean brush roll

Press handle release with foot to lower handle flat

onto floor.

Lay vacuum face down; remove any entwined long

fibers or hair using scissors (Fig. 8).

Fig 1

Fig 3

Fig 5

Fig 7

Electrolux Customer Service 1-800-896-9756

Fig 2

Fig 4

Fig 6

Fig 8