Electrolux Beam Installationshandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Installationshandbuch für Staubsauger Electrolux Beam herunter. Electrolux Beam 16 Seiten. Central

Seite drucken

LOW VOLTAGE WIRE:

The low voltage wire (24volt) is required so that you can turn the suction on,

from any inlet/socket point located in the property.

TIP: Y

OU DO NOT HAVE TO BE A REGISTERED ELECTRICIAN TO CARRY OUT THIS WORK AS

YOU ARE NOT CONNECTING TO ANY ELECTRICAL CIRCUIT TO THE MAIN PROPERTY

CIRCUIT IS JUST BETWEEN THE APPLIANCE AND THE INLET

The wire is two core (one blue wire and one brown) and must go from the

appliance and follow the pipe work wherever it goes to reach an inlet.

Cable ties and pipe brackets with clips are provided to hold the wire to the

pipe work to keep it neat.

Wherever you t-off from the main pipe route to go to an inlet, the wire

must be looped before carrying on to the next inlet, rather like the ring-

main in your house electrics. (See diagram below.) This means that you

will have two sets of wires going to each inlet.

The only place that you CUT the wire is IMMEDIATELY BEHIND the inlet.

It doesn't matter which colour wire goes to which contact, just as long as

you put both blues to one side and both browns to the other.

The wire is connected to the appliance with spade connectors into the

little sockets at the top of the appliance or the wire is just put straight into

speaker cable type connections depending on which appliance you have.

See page 9 for further information on how to wire-up the different types

of inlet.

AVING ONE WIRE GOING FROM EACH T

COULD CAUSE A PROBLEM

WILL DISABLE THE ABILITY TO TURN THE APPLIANCE ON AND OFF FROM THE INLET

MAY NOT BE ABLE TO GET TO THE LOOSE CONNECTION TO CORRECT THE FAULT

CUTTING THE WIRE BEHIND THE INLET AND LOOPING IT AROUND TO THE NEXT ONE

INSURES YOU HAVE EASY ACCESS TO CORRECT ANY LOOSE CONNECTIONS

UNSCREW THE INLET FROM THE WALL TO RECTIFY

RULE 4

Back of

Inlet

last inlet

in run

. I

N THE FUTURE IT

LOOPED TO EACH INLET

Back of

Inlet

To power

unit

PIECE FOLLOWING THE PIPE TO THE INLET

S POSSIBLE THAT A LOOSE CONNECTION

. T

. Y

. O

NLY

. (J

UST