Electrolux Beam Installationshandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Installationshandbuch für Staubsauger Electrolux Beam herunter. Electrolux Beam 16 Seiten. Central
Seite drucken
Timber Partition/Stud Walls
Side-On
Sharp 90° bend
Cable tie
NOGGIN with
55mm hole
allows pipe &
cable to go
through
8
Installing the Pipework
Screw in mounting
plate using only 1
flange into upright
timber (or noggin)
Inlet
Low voltage cable
Pipe bracket &
cable holder
screwed into
timber stud
Pipe bracket
securing pipe to
joist below floor
VacPan Installation
Personal Clothes Brush Installation
Clothes brush connector must have LV cable
connected to it and must be hung far enough
above the inlet so that the hose of the Clothes
Brush hangs naturally. Ensure wires are insulated
from each other.
This accessory is mounted on the connector
permanently unless being used, so some
thought should go into where it is to be
located.
Low voltage cable running to clothes brush
connector NOT to the dedicated wall inlet.
A dedicated inlet must be used and it is
important to run the low voltage cable past the
inlet itself, up to the clothes brush connector.
Timber Partition/Stud Walls
Face-On (without inlet shown)
Flexible Pipe
Sharp 90° Bend
Kitchen Unit
Jubilee Clip
Pipe
Plinth
VacPan Inlet
LV cable