Alert 500S LCD Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Autoalarm Alert 500S LCD herunter. Alert 500S LCD 13 Seiten.

Seite drucken

T. IGNITION CONTROL POWER DOOR LOCK SAFETY SYSTEM

(See Feature II - 3 Programming).

. Turn the ignition switch on and close all vehicle's doors. After seconds, the system will

automatically lock the central locking system.

. Turn the ignition switch off. The system will automatically unlock the central locking system.

U. TRUNK RELEASE (Factory default setting) /

CHANNEL 3 TIMER CONTROL OUTPUT

(See Alarm Feature III - 3 Programming)

Press and hold the

button on transmitter for two seconds to

remote control the trunk release or other electric devices.

Channel is user-programmable timer output. You may program the built-in timer to send a

ground signal for any time interval between second and minutes. For instance, this timer

output may be used to turn on the headlight, power window or sunroof.

Note: Factory default setting at second pulse grounded for trunk release output.

V. CHANNEL 4 TIMER CONTROL OUTPUT

(See Alarm Feature III- 4 Programming)

Press the transmitter and buttons at the same time to active Channel

4 function. Channel 4 is user-programmable timer output. You may

program the built-in timer to send a ground signal for any time inter-

val between second and minutes. For instance, this timer output

may be used to turn on the headlight, power window or sunroof.

Note: Factory defaults setting at momentary output.

W. POWER ON MEMORY

This security system is equipped with circuitry that will allow the unit to remember its alarm state

if the power is lost and then reconnected.

LCd rEMOTE TrANSCEIVEr

Note: If the system is interfered by stronger radio frequency around, sources of high voltage elec-

tric power or such Obstacles like tall buildings and so on, the transmission range may get shorter

as the system uses low output power frequency.

A. BATTERY REPLACEMENT:

A .5V type AAA Alkaline battery powers the Remote Transceiver. When the power of the battery

weakens a

icon shall be displayed on the LCD screen. When the old battery is replaced to new

one, there will be beep sounds indicate the power is up and the clock on the LCD screen returns

to AM:00 after displaying all the icons. Correct the time by pressing for seconds before using

(See Timer Setting).

Note : press the button two times when the battery compartment is empty, then

insert the new battery.

B. THE REMOTE LCD ICONS WITH FUNCTION

door Lock

Your vehicle doors are locked

ARM

Armed Mode

Your vehicle is in armed mode

door Unlock

Your vehicle doors are unlocked

and the system is Disarmed

Valet Mode

All the function shall be temporar-

ily on hold