Bose Lifestyle 35 Series II Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kopfhörer Bose Lifestyle 35 Series II herunter. Bose Lifestyle 35 Series II 13 Seiten. Noise cancelling
Auch für Bose Lifestyle 35 Series II: Installationshandbuch (42 seiten), Installationshandbuch (36 seiten), Benutzerhandbuch (25 seiten), Benutzerhandbuch (24 seiten), Handbuch zur Schnelleinrichtung (3 seiten), Betriebshandbuch (46 seiten), Benutzerhandbuch (36 seiten), Benutzerhandbuch (32 seiten), Schnellstart-Handbuch (2 seiten), Werksreset (2 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (38 seiten)

Bose Lifestyle 35 Series II Benutzerhandbuch
English
Dansk
If you have not yet done so, now is a good time to find the serial number on the bottom of the
SL2 transmitter, then copy it in the space provided on "For your records" on page 3.
Setting the transmitter for your system
If your speakers are part of an Acoustimass
the bottom of the SL2 transmitter to Other (Figure 2).
Figure 2
Speaker switch
Switch
For use of a LIFESTYLE
switch setting is optimal. There is no need to change the setting.
Important note: Running the ADAPTiQ
LIFESTYLE
after the SL2 is connected and your surround speakers are in the final position.
Choosing positions for your SL2 transmitter and receiver
Radio frequency transmissions make this product easy to place. It is seldom necessary to
point the SL2 transmitter at its receiver. This allows you to hide both from view if you like.
The SL2 transmitter, identified on the label, is also distinguished by a single input jack
(see Figure 3 on page 6). The SL2 receiver, which is also labeled, has two output jacks.
1. Place the SL2 transmitter within 6
Make sure it is within reach of an AC (mains) outlet.
2. Place the SL2 receiver at the same end of the room as your surround speakers.
It, too, should be within reach of an AC (mains) outlet.
Position the transmitter/receiver pair:
From 6
Where the sides are unobstructed to allow for ventilation.
Upright (neither upside down nor on a side) on the floor or other flat, stable surface.
Note: If you experience any problem with communications between the SL2 transmitter
and receiver, positioning them within line of sight to each other may be helpful. For further
suggestions on how to deal with such problems, refer to "Troubleshooting" on page 9.
Deutsch
Español
Bottom of the
SL2 transmitter
®
system with the SL2 Wireless Surround Link, the current default
®
system, helps ensure the most accurate sound from your system. Be sure to use it
1
/
feet (2 meters) to 30 feet (9.2 meters) apart.
2
Français
Italiano
Y
OUR
®
speaker system, you need to set the switch on
®
audio calibration system, which is provided with your
1
/
feet (2 meters) of the Acoustimass
2
Nederlands
Svenska
SL2
WIRELESS SURROUND LINK
®
module.
5