Bose Lifestyle 35 Series II Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Headsets Bose Lifestyle 35 Series II. Bose Lifestyle 35 Series II 13 pages. Noise cancelling
Also for Bose Lifestyle 35 Series II: Installation Manual (42 pages), Installation Manual (36 pages), Owner's Manual (25 pages), Owner's Manual (24 pages), Quick Setup Manual (3 pages), Operating Manual (46 pages), Owner's Manual (36 pages), Owner's Manual (32 pages), Quick Start Manual (2 pages), Factory Reset (2 pages), Quick Start Manual (2 pages), Owner's Manual (38 pages)

Print Page

Bose Lifestyle 35 Series II Owner's Manual

English

Dansk

If you have not yet done so, now is a good time to find the serial number on the bottom of the

SL2 transmitter, then copy it in the space provided on "For your records" on page 3.

Setting the transmitter for your system

If your speakers are part of an Acoustimass

the bottom of the SL2 transmitter to Other (Figure 2).

Figure 2

Speaker switch

Switch

For use of a LIFESTYLE

switch setting is optimal. There is no need to change the setting.

Important note: Running the ADAPTiQ

LIFESTYLE

after the SL2 is connected and your surround speakers are in the final position.

Choosing positions for your SL2 transmitter and receiver

Radio frequency transmissions make this product easy to place. It is seldom necessary to

point the SL2 transmitter at its receiver. This allows you to hide both from view if you like.

The SL2 transmitter, identified on the label, is also distinguished by a single input jack

(see Figure 3 on page 6). The SL2 receiver, which is also labeled, has two output jacks.

1. Place the SL2 transmitter within 6

Make sure it is within reach of an AC (mains) outlet.

2. Place the SL2 receiver at the same end of the room as your surround speakers.

It, too, should be within reach of an AC (mains) outlet.

Position the transmitter/receiver pair:

•

From 6

•

Where the sides are unobstructed to allow for ventilation.

•

Upright (neither upside down nor on a side) on the floor or other flat, stable surface.

Note: If you experience any problem with communications between the SL2 transmitter

and receiver, positioning them within line of sight to each other may be helpful. For further

suggestions on how to deal with such problems, refer to "Troubleshooting" on page 9.

Deutsch

Español

Bottom of the

SL2 transmitter

system with the SL2 Wireless Surround Link, the current default

system, helps ensure the most accurate sound from your system. Be sure to use it

feet (2 meters) to 30 feet (9.2 meters) apart.

Français

Italiano

OUR

speaker system, you need to set the switch on

audio calibration system, which is provided with your

feet (2 meters) of the Acoustimass

Nederlands

Svenska

SL2

WIRELESS SURROUND LINK

module.