anko LD-T1002 Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Toaster anko LD-T1002 herunter. anko LD-T1002 8 Seiten.
FOR THE FIRST USE
Manufacturing residue or oil remained in the toaster heating element may emit an
odour when used for the first time, this is normal and will disappear after few minutes
of use. When using for the first time, we suggest following the below steps under
the heading USING YOUR TOASTER, except without bread. Then let the toaster
cool down and begin toasting the first slice.
CAUTION: The bread may burn, therefore toaster must not be used near or
below curtains and other combustible materials. The toaster should be
attended when in use.
USING YOUR TOASTER
Important: Never let the toaster operate unattended.
Important: Do not operate the toaster without the crumb tray.
Important: Never use the appliance when it is empty (when there is no bread inside)
except on first use.
CAUTION: Do not attempt to use the toaster without the glass panel. Do not
use if the glass panel has been damaged, i.e. cracked or chipped.
Toasting
1. Unwind the power cable to the required length and plug it in.
2. Use the Selector (6) to set the required toasting level between 1 and 6. For a
medium, golden brown, select level 3-4.
3. Place the bread to be toasted in the Toasting slot (1).
4. Press the Push-down lever (2) down
button (5)
will
5. Toasting ends when the bread being toasted is
button (5) will go off.
6.
Your toast will pop up automatically. To raise it higher, lift the lever.
Note: The toasting can be interrupted at any time by pressing the CANCEL
button (5).
Note:
Push-down lever (2)
The
in.
Tip: If you toast only one slice of bread, set the toasting level lower than you would
normally use for two slices.
Tip: The Push-down lever (2) can be lifted manually, so smaller items can be
easily removed from the Toasting slot (1).
illuminate.
locks. The LED on the CANCEL
until it
pops
will not stay down unless the toaster is plugged
4
up. The LED on the CANCEL