anko LD-T1002 User Manual - Page 5

Browse online or download pdf User Manual for Toaster anko LD-T1002. anko LD-T1002 8 pages.

Print Page

FOR THE FIRST USE

Manufacturing residue or oil remained in the toaster heating element may emit an

odour when used for the first time, this is normal and will disappear after few minutes

of use. When using for the first time, we suggest following the below steps under

the heading USING YOUR TOASTER, except without bread. Then let the toaster

cool down and begin toasting the first slice.

CAUTION: The bread may burn, therefore toaster must not be used near or

below curtains and other combustible materials. The toaster should be

attended when in use.

Important: Never let the toaster operate unattended.

Important: Do not operate the toaster without the crumb tray.

Important: Never use the appliance when it is empty (when there is no bread inside)

except on first use.

CAUTION: Do not attempt to use the toaster without the glass panel. Do not

use if the glass panel has been damaged, i.e. cracked or chipped.

Toasting

1. Unwind the power cable to the required length and plug it in.

2. Use the Selector (6) to set the required toasting level between 1 and 6. For a

medium, golden brown, select level 3-4.

3. Place the bread to be toasted in the Toasting slot (1).

4. Press the Push-down lever (2) down

button (5)

will

5. Toasting ends when the bread being toasted is

button (5) will go off.

Your toast will pop up automatically. To raise it higher, lift the lever.

Note: The toasting can be interrupted at any time by pressing the CANCEL

button (5).

Note:

Push-down lever (2)

The

in.

Tip: If you toast only one slice of bread, set the toasting level lower than you would

normally use for two slices.

Tip: The Push-down lever (2) can be lifted manually, so smaller items can be

easily removed from the Toasting slot (1).

illuminate.

locks. The LED on the CANCEL

until it

pops

will not stay down unless the toaster is plugged

up. The LED on the CANCEL