Anolis ArcPad 48 Integral Gebrauchsanweisung
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Beleuchtungsanlagen Anolis ArcPad 48 Integral herunter. Anolis ArcPad 48 Integral 3 Seiten.
Seite druckenThe product generates colored light by means of Luxeon LEDs.The product was designed for exterior use
and it is ideal for locations where the effect lighting is required.
1.Attention:
During the operation the housing becomes hot (up to 85°C)
Do not install the module near high inflammable liquids or materials
Do not allow anything to rest on the module
Do not install the module near the naked flames
The unit is not suitable for underwater installation
Do not install the module in dirty,dusty or badly ventilated location
Avoid using the unit in locations subject to possible impacts.
Avoid looking directly into the LED light beam at close range.
2.Installation
The ArcPad 48 unit can be arranged in any position orientation.The ArcPad´s head is mounted on an adjustable
bracket for "tilt" adjustment into many positions.
To fix the unit.
1. Loosen both pan screws (1) in the fixture base.
2. Turn the internal adjustable holder (2) to the position
as shown on the picture and take it out from the base.
3. Fasten the internal holder on the non-flammable surface
via 2 mounting holes of diameter of 9.2 mm.
4. Put the base of the fixture on the internal holder (2) ,adjust
its desired pan position and tighten both pan screws (). Adjust suitable
tilt position.
The ArcPpad 3•48 should be connected to the ArcPower 48 driver. See the ArcPower 48 user manual for full
User instructions
ArcPad 48