Anolis ArcPad 48 Integral 사용자 지침

{카테고리_이름} Anolis ArcPad 48 Integral에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcPad 48 Integral 3 페이지.

The product generates colored light by means of Luxeon LEDs.The product was designed for exterior use

and it is ideal for locations where the effect lighting is required.

1.Attention:

During the operation the housing becomes hot (up to 85°C)

Do not install the module near high inflammable liquids or materials

Do not allow anything to rest on the module

Do not install the module near the naked flames

The unit is not suitable for underwater installation

Do not install the module in dirty,dusty or badly ventilated location

Avoid using the unit in locations subject to possible impacts.

Avoid looking directly into the LED light beam at close range.

2.Installation

The ArcPad 48 unit can be arranged in any position orientation.The ArcPad´s head is mounted on an adjustable

bracket for "tilt" adjustment into many positions.

To fix the unit.

1. Loosen both pan screws (1) in the fixture base.

2. Turn the internal adjustable holder (2) to the position

as shown on the picture and take it out from the base.

3. Fasten the internal holder on the non-flammable surface

via 2 mounting holes of diameter of 9.2 mm.

4. Put the base of the fixture on the internal holder (2) ,adjust

its desired pan position and tighten both pan screws (). Adjust suitable

tilt position.

The ArcPpad 3•48 should be connected to the ArcPower 48 driver. See the ArcPower 48 user manual for full

User instructions

ArcPad 48