3M W-2806/07006 Gebrauchsanweisung - Seite 15

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Monitor 3M W-2806/07006 herunter. 3M W-2806/07006 19 Seiten. Compressed air filter and regulator panel
Auch für 3M W-2806/07006: Allgemeine Betriebs- und Teileanleitung (2 seiten)

Seite drucken

Wire Color

Detector Terminal

Black

CNTR

Blue

REF

Red

SENSING

Be sure flow block cavity and o-ring are dry

and clean of oils, dirt etc. The o-ring must be

positioned evenly in the bottom of the flow

block cavity. Push the sensor into block against

o-ring and evenly tighten the 2 screws that hold

the circuit board/sensor to flow block. Tighten

screws lightly to assure good seal with o-ring.

Do not overtighten screws or damage to circuit

board/sensor may occur.

Replace the bottom plate and secure it

with thumbscrews.

Make sure the inlet sample swivel elbow

is firmly tightened.

Allow at least one hour for stabilization,

then calibrate as in Calibration and Adjustment

section of this User Instruction.

Circuit board/

sensor to flow

block mounting

screws.

Wire connectors'

circuit board

"CO" sensor cell

O-ring

Flow block

Fig. 4