DSC PC5100 Installationsanleitung Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Sicherheitssystem DSC PC5100 herunter. DSC PC5100 12 Seiten. 2-wire addressable device interface module

Seite drucken

DSC PC5100 Installationsanleitung Handbuch

3.4 Module and Device Supervision

To confirm that the panel is supervising the PC5100, enter section

[903]. If the PC5100 is being supervised, on LED keypads light 15 will

be on, and on LCD keypads the message "PC5100" will be displayed.

Devices are supervised as zones. The level of supervision for AML

devices is determined by the type of zone supervision that was se-

lected for the PC5010/5015 (i.e. normally closed, single end of line, or

double end of line supervision).

For more information, please refer to your PC5010 or PC5015 Installa-

tion Manual .

3.5 Removing Devices

Before removing devices from the system, you must delete their serial

numbers. To remove a 2-wire addressable device from the system,

perform the steps outlined in Section 3.2. Enter [00000] for the serial

number of the device you wish to remove.

You may need to power down the panel to clear troubles which

could be caused by deleted devices.

3.6 Replacing Devices

In order to replace an AML device, you must first remove the old

device, as described in section 3.5, above. Then, enroll the new device

as described in section 3.2.

3.7 Programming Section Descriptions

Sections [01] - [32]: Zone Serial Numbers

These sections are for enrolling the serial numbers of each 2-wire

addressable device on the system. See Section 3.2 for details.

Section [97]: Special Functions

Option 1: Walk test light ON. Turn on this option to enable the walk

test LED on all motion and glassbreak detectors. If a device is working,

its LED will turn on when it is tested.

This option does not turn on the walk test - only the walk test

LEDs. To walk test the system, follow the instructions in the

Walk Test section of the PC5010 or PC5015 Installation Manual.

• To test the motion detectors, create motion in front of each device. If

the LED turns on, the device is working.

• To test the glassbreak detectors, you will also need to turn on option

4 (Glassbreak Test ON). See the AMA-100 Installation Instruction

sheet for testing instructions.

Once the walk test has been completed, re-enter Section [97] and turn

option [1] OFF.

Option 2: Smoke test on installer exit. Turn on this option to enable

the smoke test for all AML smoke detectors. The PC5100 will begin the

test after you exit from Installer's Programming. The PC5100 tests each

smoke detector by:

• turning on the test output of each detector, and then checking for an

alarm state on each detector