DSC PC5102-433 Installationshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationshandbuch für Sicherheitssystem DSC PC5102-433 herunter. DSC PC5102-433 13 Seiten.

Seite drucken

Testing Individual Wireless Keys

To ensure that the PC5102-433 receiver is receiving transmissions from these devices,

use the function keys on the (P)WLS909-433/(P)WLS919-433 at several different locations

in the installation.

5.2

Mount the PC5102-433

When you have tested reception of the PC5102-433 with all the wireless devices (see

section 5.1) and you have a good mounting location, mount the PC5102:

1. Pull the Keybus wires through the hole at the bottom of the back part of the

cabinet.

2. Mount the cabinet securely to the wall using the two 'ears' of the cabinet or using

the two mounting holes inside the cabinet. To use holes inside the cabinet, the

PCB must first be removed. To remove the PCB, release it from the two tabs at the

bottom of the PCB and then lift it out.

Caution: Do not touch the antenna or the coils as this could damage the unit and will

result in improper operation.

Note: If you are not using the 'ears' to mount the cabinet, you can break these off.

Now that your PC5102-433 and wireless devices are mounted and working properly, read

Section 6 for information on potential wireless trouble conditions and battery replacement.

Section 6: Additional Notes

6.1

Trouble Conditions

The control panel always watches for possible trouble conditions. If a trouble condition

occurs, the keypad "Trouble" light will turn on and the keypad will beep. Press [✱][2] to

display the trouble conditions.

The following trouble conditions apply to the PC5102-433 and/or any enrolled wireless keys.

General System Supervisory - This trouble will be generated if the panel loses

communication with any module connected to the Keybus. The event buffer will

log a detailed description of the event.

Device Low Battery - This trouble is generated when a wireless device exhibits a

low battery condition. Press [7] one, two, or three times to view which devices

are experiencing battery failure. An LED keypad will indicate battery failure

using zone lights 1 to 8.

6.2

Wireless Zone Low Battery Transmission

Within any transmission, the device will indicate the status of the battery. If a battery is low,

the system will indicate a Device Low Battery trouble. The system will delay reporting the

event to the central station for the number of days programmed for Zone Low Battery

Transmission Delay in section [370]. This will prevent unnecessary reporting of the event

if the user has been instructed on how to replace batteries.

Replacing Batteries in Wireless Devices

1. Remove the cover of the device from its back plate.

2. Refer to the battery installation instructions on the installation sheet of each

component. Be sure to note the proper orientation of the batteries as you install them.

3. When the fresh batteries are in place, re-attach the cover to the back plate. The battery

trouble will clear when any button is pressed after the installation of the new

batteries and the device should function normally.

NOTE

NOTE: When batteries in one device need to be replaced, the batteries in all devices

NOTE

may need to be replaced at the same time.

firealarmresources.com