DSC AMB-300 Einbauanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Einbauanleitung für Sicherheitssensoren DSC AMB-300 herunter. DSC AMB-300 4 Seiten. Addressable pir detector

Mounting

To open the case, use a small flat blade screwdriver and gently push in the tab at the

bottom of the case and pull the cover straight out at the bottom. Loosen the printed

circuit board screw, and push the board up as far as it will go. Using a small screw-

driver, remove the appropriate knockouts for the mounting screws. Remove the

desired wiring entrance knockouts located at the top or bottom of the backplate.

Mount the backplate.

Locate mounting screws diagonally opposite each other to prevent the case from

warping.

Device Enrollment

The serial number located on the back of the device must be enrolled into the alarm

control panel via Installer's Programming ([✱] [8] [Installer's Code]). This procedure is

outlined for the PC4010/4020 in the control panel Installation Manual and for the

Power panels in the PC5100 Installation Manual.

WARNING: Connect only DSC Addressable Series devices to the addressable

loop connections. Connection of ANY other type of device will impair operation.

Any devices other than Addressable Series devices which require power to oper-

ate must be powered separately.

Vertical Adjustment

NOTE: Range and dead zones may vary due to settings.

Using the figures listed below, set the vertical adjustment to get the desired coverage.

Ensure that the PCB retaining screw is tightened just enough to prevent board movement.

Moving the circuit board down will increase the far range and bring the near beams closer

to the mounting wall. Moving the circuit board UP will reduce the far range and move the

near beams farther out from the mounting wall. Moving the circuit board UP too much will

cause the far beams to "look" above the target; as a result, the range may appear shorter.

Jumper J1 selects between harsh and normal environments. For a typical environ-

ment or one containing a small pet (height less than 1.2 ft/0.36 m), set the unit as nor-

mal (J1 ON). For a large pet and multiple pets, the jumper J1 should be removed.

Walk Testing

Once the detector has been set up, walk test the entire area where coverage is

desired. Should the coverage be incomplete, readjust or relocate the detector to

obtain full coverage.

IMPORTANT NOTE: Upon installation, the unit should be thoroughly tested to

verify proper operation. The end user should be instructed on how to perform

walk tests, and should walk test the detector weekly.