DSC LCD 5500 Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Bedienfeld DSC LCD 5500 herunter. DSC LCD 5500 17 Seiten. Security station for power 832 security system
Auch für DSC LCD 5500: Gebrauchsanweisung (20 seiten)

Seite drucken

Disarming

Enter the premises only through the door(s) designated by your installer as the entry door(s).

Entering by any other door will sound an immediate alarm.

Upon entering through the designated entry door, the keypad display will begin to sound an audible

warning and display the following message..

If an Alarm Sounds

Fire Alarm

If your system has been installed with fire detectors and the alarm sounds in a pulsing mode, follow

your emergency evacuation plan immediately. See guidelines for Family Escape Planning elsewhere

in this manual.

Intrusion Alarm

If an intrusion alarm sounds (continuous bell/siren), the alarm may be silenced by entering your

security code. Transmission to the monitoring station will NOT be interrupted by silencing the alarm

unless a transmission delay is put in by your installer. If the alarm was unintentional, notify the

monitoring service or local authorities immediately.

You may determine the source of the alarm by going to the Alarm Viewing section. Once the source

of the alarm has been corrected, the panel can be restored to its original armed state.

If an error is made in entering the code, press the [#] key and enter the code

again.

The correct security code must be entered before the "entry" time expires

or the system will go into alarm. Your installer can change the entry time. If no

alarms occurred while the panel was armed, and there are no troubles, the

display will read..

After about 5 seconds this message will be displayed and the system will be

disarmed.

Upon disarming and if an ALARM occurred during the period the system was

armed, this message will be displayed.

After viewing alarms and if a zone is still in alarm, the display will show this

message to indicate that a zone is open.

Upon Disarming and if a TROUBLE is present, this message will be displayed.