ATSI LST-650 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte ATSI LST-650 herunter. ATSI LST-650 10 Seiten. Nema load switch tester

Seite drucken

Test Manager Software Installation

Before using the Tester, the LST-650 Test Manager software must be installed on the computer that will be
connected to the tester. A USB driver is also required to be installed.The software and USB driver may be
downloaded at www.atsi-tester.com.
The computer requirements are as follows:
● Windows 10 or later operating system.
● At least one available USB port.

Running a Test

● Connect the computer to the USB port on the front of the Tester using the supplied USB cable.
● Connect the supplied power cable to the rear of the tester and plug into a 120VAC, 60Hz outlet.
● Start the LST-650 Test Manager software.
● Insert the Load Switch to be tested into the socket on the front of the Tester.
● Turn the power switch to the ON position.
● Use the software to control the Tester (see below):
1. Enter in the ID or serial number for the Load Switch to be tested (optional).
2. Enter in the manufacturer for the Load Switch to be tested (optional).
3. Start the full test
4. Save the test report
5. Manually turn on the Red channel
6. Manually turn on the Yellow channel
7. Manually turn on the Green channel
8. Check communications with the Tester and get Tester information
9. Update the Tester firmware
LST-650 User's Manual v1
Page 5 of 10