ATSI LST-650 사용자 설명서 - 페이지 5

{카테고리_이름} ATSI LST-650에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATSI LST-650 10 페이지. Nema load switch tester

Test Manager Software Installation

Before using the Tester, the LST-650 Test Manager software must be installed on the computer that will be

connected to the tester. A USB driver is also required to be installed.The software and USB driver may be

downloaded at www.atsi-tester.com.

The computer requirements are as follows:

● Windows 10 or later operating system.

● At least one available USB port.

● Connect the computer to the USB port on the front of the Tester using the supplied USB cable.

● Connect the supplied power cable to the rear of the tester and plug into a 120VAC, 60Hz outlet.

● Start the LST-650 Test Manager software.

● Insert the Load Switch to be tested into the socket on the front of the Tester.

● Turn the power switch to the ON position.

● Use the software to control the Tester (see below):

1. Enter in the ID or serial number for the Load Switch to be tested (optional).

2. Enter in the manufacturer for the Load Switch to be tested (optional).

3. Start the full test

4. Save the test report

5. Manually turn on the Red channel

6. Manually turn on the Yellow channel

7. Manually turn on the Green channel

8. Check communications with the Tester and get Tester information

9. Update the Tester firmware

LST-650 User's Manual v1

Page 5 of 10