ATTA Freedom Fill Installationsanweisung - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanweisung für Zubehör für Kraftfahrzeuge ATTA Freedom Fill herunter. ATTA Freedom Fill 10 Seiten. Auxiliary system
Auch für ATTA Freedom Fill: Handbuch zur Fehlersuche (5 seiten)
1. Mount the Gauge & Switch Console on desired location on dash. Note: Attach locking suction cup to
console arm to mount on windshield. Clean surface area to insure proper seal of suction cup. Or remove
suction cup to mount directly to dash. Run wires to the underside of the instrument cluster. Insure the
wires will not interfere with any moving parts (IE: brake pedals, parking brake, etc.). It may be
necessary to drill a hole for routing of wires. (NOTE: When routing wires, it is not necessary to pull
wires tight, give yourself some slack).
EXAMPLE OF MOUNTING POSITION OPTIONS SHOWN BELOW:
2. Place the Freedom Fill Controller Box under the instrument panel, (It may be necessary to remove the
dash panel). This can be done by using two zip-ties to attach the controller to a factory harness or
bracket. Insert the Controller harness to the Controller Box.
DO NOT PLUG IN COMPUTER MODULE WITH THE POWER ON, THIS MAY DAMAGE
THE COMPUTER MODULE!!
3. Connect the GREEN wire from the Gauge & Switch Console and Controller Harness to chassis ground.
This can be done by attaching a small eyelet to the wire and using a self-tapping screw to a chassis
ground.
4. See owner's manual for location of either a spare fuse or upfitter fuse. Connect the RED wire off the
switch to a 12 volt ignition power source. When using a factory fuse, tap into the cold side of fuse. The
cold side is the side of the fuse with no power in the fuse panel when fuse is blown. Note: Spare,
Auxiliary, Upfitter or SEO (Special Equipment Option) fuses are not used in any factory system and
should be used when adding any accessory part. Do not connect red wire to direct battery power. To
add the 15 amp inline fuse to the red wire, cut the red wire and place one end of the wire inside the fuse
holder and clamp that side down. Place the other side of the wire to the other side of the fuse holder and
clamp down. Insure each side of the fuse holder is properly in the locked position. Insert the 15 amp
fuse to the fuse holder at the end of the installation.
2