ATTA Freedom Fill Instruções de instalação - Página 2

Procurar online ou descarregar pdf Instruções de instalação para Acessórios para automóveis ATTA Freedom Fill. ATTA Freedom Fill 10 páginas. Auxiliary system
Também para ATTA Freedom Fill: Manual de resolução de problemas (5 páginas)

Imprimir página

1. Mount the Gauge & Switch Console on desired location on dash. Note: Attach locking suction cup to

console arm to mount on windshield. Clean surface area to insure proper seal of suction cup. Or remove

suction cup to mount directly to dash. Run wires to the underside of the instrument cluster. Insure the

wires will not interfere with any moving parts (IE: brake pedals, parking brake, etc.). It may be

necessary to drill a hole for routing of wires. (NOTE: When routing wires, it is not necessary to pull

wires tight, give yourself some slack).

EXAMPLE OF MOUNTING POSITION OPTIONS SHOWN BELOW:

2. Place the Freedom Fill Controller Box under the instrument panel, (It may be necessary to remove the

dash panel). This can be done by using two zip-ties to attach the controller to a factory harness or

bracket. Insert the Controller harness to the Controller Box.

DO NOT PLUG IN COMPUTER MODULE WITH THE POWER ON, THIS MAY DAMAGE

THE COMPUTER MODULE!!

3. Connect the GREEN wire from the Gauge & Switch Console and Controller Harness to chassis ground.

This can be done by attaching a small eyelet to the wire and using a self-tapping screw to a chassis

ground.

4. See owner's manual for location of either a spare fuse or upfitter fuse. Connect the RED wire off the

switch to a 12 volt ignition power source. When using a factory fuse, tap into the cold side of fuse. The

cold side is the side of the fuse with no power in the fuse panel when fuse is blown. Note: Spare,

Auxiliary, Upfitter or SEO (Special Equipment Option) fuses are not used in any factory system and

should be used when adding any accessory part. Do not connect red wire to direct battery power. To

add the 15 amp inline fuse to the red wire, cut the red wire and place one end of the wire inside the fuse

holder and clamp that side down. Place the other side of the wire to the other side of the fuse holder and

clamp down. Insure each side of the fuse holder is properly in the locked position. Insert the 15 amp

fuse to the fuse holder at the end of the installation.