2B Technologies 408 Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Messgeräte 2B Technologies 408 herunter. 2B Technologies 408 7 Seiten. Portable n2o source

Figure 2. Diagram of the Portable N

Model 408: If you have a newer instrument that has a regulator mount on the left

side panel, proceed to Step 2. Otherwise, a new left side panel with the correct

mounting holes will need to be requested from 2B Tech and installed. Remove all

of the screws around the enclosure front and back panels, including the screws on

the front bezel. Remove the left panel while keeping the top and bottom panels of

the instrument from sliding. Install the regulator mount on the left panel using the

two #10 pan head screws and split locking washer supplied with the Portable N

Source. Install the left panel on the instrument and install all of the screws at the

front and back panels of the enclosure.

Figure 3. Diagram of the Portable N

2) Loosen the single #10 socket cap screw (see Figure 1) to allow the regulator

assembly to slide into the mount.

3) Slide the regulator assembly into the mount from the top. Position the regulator

assembly so that the mount is centered on the top part of the piercing device,

not the black cartridge cup (see Figure 4). Tighten the #10 socket cap screw to

secure the assembly in the mount.

O Source mounted on a Model 211.

O Source mounted on a Model 408.

Portable N

O Source Manual Rev. B-2