2B Technologies 408 매뉴얼 - 페이지 4

{카테고리_이름} 2B Technologies 408에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2B Technologies 408 7 페이지. Portable n2o source

Figure 2. Diagram of the Portable N

Model 408: If you have a newer instrument that has a regulator mount on the left

side panel, proceed to Step 2. Otherwise, a new left side panel with the correct

mounting holes will need to be requested from 2B Tech and installed. Remove all

of the screws around the enclosure front and back panels, including the screws on

the front bezel. Remove the left panel while keeping the top and bottom panels of

the instrument from sliding. Install the regulator mount on the left panel using the

two #10 pan head screws and split locking washer supplied with the Portable N

Source. Install the left panel on the instrument and install all of the screws at the

front and back panels of the enclosure.

Figure 3. Diagram of the Portable N

2) Loosen the single #10 socket cap screw (see Figure 1) to allow the regulator

assembly to slide into the mount.

3) Slide the regulator assembly into the mount from the top. Position the regulator

assembly so that the mount is centered on the top part of the piercing device,

not the black cartridge cup (see Figure 4). Tighten the #10 socket cap screw to

secure the assembly in the mount.

O Source mounted on a Model 211.

O Source mounted on a Model 408.

Portable N

O Source Manual Rev. B-2