DTC PB-5 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Transmitter DTC PB-5 herunter. DTC PB-5 16 Seiten. Beacon transmitter

Test Push-button

Holding this push-button, while powering up, causes the unit to go into test mode.

Based on the break wire and standby wire inputs, the unit will go into one of the

four transmit modes.

Break wire

Standby wire

None

Init Push-button

Holding the init switch for one second, re-initializes the unit. It reads the mode/

channel switch and can be used to change the channel/mode without cycling the

power. The LED blinks once. If the init switch is held for more than 5 seconds, the

unit is switched to default mode. This is indicated by 5 LED blinks, a short delay,

and then one LED blink.

Tone: 1000 Hz on all channels

Default Confidence tone interval: 30 seconds

Battery Monitoring: Disabled

Standby: On closed on all channels

Break wire: Auto configured on all channels

RF Output

Connect the antenna to this connector.

RS232 Connector

The programming cable is connected to this connector when programming is

required.

Transmit Output

Continuous Tone

Tracking Pulses

Unmodulated Carrier

Default Settings:

CONNECTIONS

Channel/Mode switch

LED light

Test push-button

Init push-button

Antenna connector

Programming Cable Connector

DTC COMMUNICATIONS, INC.