DAMPP-CHASER Piano Life Saver System Installationsanleitung Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Musikinstrument DAMPP-CHASER Piano Life Saver System herunter. DAMPP-CHASER Piano Life Saver System 9 Seiten. Backside vertical 8-part system which includes two humidifiers
Auch für DAMPP-CHASER Piano Life Saver System: Einbauanleitung (4 seiten), Installationsanleitung Handbuch (8 seiten), Pflege- und Wartungshinweise (2 seiten)
Seite drucken
Ideally, the lower corner of the Humidistat should be positioned
5 cm above the top of the Humidifier tank and 5 cm away from
the side of the Humidifier tank (Figure 14). With a suspended
tank, the Humidistat should also be positioned approximately
5 cm above and 5 cm from the side of the tank.
Now, plug the Dehumidifier and the Humidifier into the Humi-
distat. Make sure you do not put the plugs into the wrong
outlets. Connect the separate 3 m extension power cord to the
Humidistat outlet which is below the DEHUMIDIFIER outlet.
Then, route this Humidistat power cord out of the piano. First
run the 3 m cord to the treble end. Then run it up beside the
action and out the lid (Figure 15). From there the cord goes
down to an electrical outlet. With experience you will develop
your own technique for bringing the cord out under the lid. The
6 mm clamps may be used to attach the cord to the inside of
the piano.
FIGURE 14
Typical
Humidistat position
Dehumidifier
Power cord to
electrical outlet
You may prefer another method of running the power cord out
of the piano. If you feel comfortable drilling a hole in the
bottom board, you can bring the power cord out through the
hole (Figure 16). To provide strain relief for the cord, knot it
and secure the knot to an appropriate wood area with one of
the 6 mm clamps provided.
From the Humidifier tank, take the white cord, with the tele-
phone jack adaptor, and plug it into the Humidistat outlet
marked WATER SENSOR (Figure 17). Plug the Smart
Bracket's phono jack adaptor into the outlet marked
SB/PADS. Using wire ties and cable ties, neatly rebundle
excess cords for the Dehumidifier, Humidifier, Water Sensor
and Smart Bracket.
FIGURE 15
Routing the power cord
out of the piano
6
FIGURE 16
Alternate method for running
power cord out of piano
FIGURE 17
Humidifier
Heater
Bar