DAN NTP TECHNOLOGY DAD Thunder Core 256 Installationshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installationshandbuch für Aufnahmegeräte DAN NTP TECHNOLOGY DAD Thunder Core 256 herunter. DAN NTP TECHNOLOGY DAD Thunder Core 256 16 Seiten. Thunderbolt 3, dante, madi and adat digital audio interface

Seite drucken

Installation Guide Core 256

The installation sequence:

1. Copy the driver .pkg file to the computer desktop and double click to start the installation.

2. Follow the installation instructions. Click Next and then Install.

3. Enter Administrator password and click Install.

4. If the driver has not been installed before on the computer, you get the message "System extension

blocked". Click on Open Security Preferences.

5. In the "Security and Privacy" window you have to click on the lock symbol in the bottom left corner and

unlock settings and click Allow.

6. Restart the Computer and open the Thunderbolt 3 driver application and connect the DAD

Thunder|Core interface to the USB-C/Thunderbolt 3 port on the Computer. Make sure that you are

using a high-speed (20Gbps) Thunderbolt 3 USB-C cable.

For mor information how to install and configure the Thunderbolt 3 driver please refer to the Thunder|Core

installation guide on www.digitalaudiosupport.com.

Once the driver is installed the device can be attached to via the setup window.

Installation of DAD Thunderbolt 3 driver on Windows PC

The driver software has to be installed completely in order to function properly.

When you install the driver, it is of no importance whether you have units or other peripherical devices

connected to the Thunderbolt 3 / USB-C port on the computer. In the process described below there are no

devices connected before installation.

The installation sequence is the following:

1. Copy the driver .msi windows installer file to the computer desktop and double click in order to start

installation.

2. Follow the installation instructions. Click Next and then Install.

3. Once the driver is installed, open your audio application and choose the Digital Audio Denmark ASIO

driver.

4. In order to configure the ASIO driver, open the ASIO dialogue window in the audio configuration section

of your audio application.

5. Configuration can be done on the parameters shown in figure 6.

Doc no. AXCNTR-8001-A-4

Figure 4, DADDriver setup window for MacOS

Rev. date 201123

Page 9 of 16