DAN NTP TECHNOLOGY DAD Thunder Core 256 Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу для Обладнання для запису DAN NTP TECHNOLOGY DAD Thunder Core 256. DAN NTP TECHNOLOGY DAD Thunder Core 256 16 сторінок. Thunderbolt 3, dante, madi and adat digital audio interface
Друкувати сторінкуInstallation Guide Core 256
The installation sequence:
1. Copy the driver .pkg file to the computer desktop and double click to start the installation.
2. Follow the installation instructions. Click Next and then Install.
3. Enter Administrator password and click Install.
4. If the driver has not been installed before on the computer, you get the message "System extension
blocked". Click on Open Security Preferences.
5. In the "Security and Privacy" window you have to click on the lock symbol in the bottom left corner and
unlock settings and click Allow.
6. Restart the Computer and open the Thunderbolt 3 driver application and connect the DAD
Thunder|Core interface to the USB-C/Thunderbolt 3 port on the Computer. Make sure that you are
using a high-speed (20Gbps) Thunderbolt 3 USB-C cable.
For mor information how to install and configure the Thunderbolt 3 driver please refer to the Thunder|Core
installation guide on www.digitalaudiosupport.com.
Once the driver is installed the device can be attached to via the setup window.
Installation of DAD Thunderbolt 3 driver on Windows PC
The driver software has to be installed completely in order to function properly.
When you install the driver, it is of no importance whether you have units or other peripherical devices
connected to the Thunderbolt 3 / USB-C port on the computer. In the process described below there are no
devices connected before installation.
The installation sequence is the following:
1. Copy the driver .msi windows installer file to the computer desktop and double click in order to start
installation.
2. Follow the installation instructions. Click Next and then Install.
3. Once the driver is installed, open your audio application and choose the Digital Audio Denmark ASIO
driver.
4. In order to configure the ASIO driver, open the ASIO dialogue window in the audio configuration section
of your audio application.
5. Configuration can be done on the parameters shown in figure 6.
Doc no. AXCNTR-8001-A-4
Figure 4, DADDriver setup window for MacOS
Rev. date 201123
Page 9 of 16