concept 2 DYNO Montageanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Fitnessgeräte concept 2 DYNO herunter. concept 2 DYNO 12 Seiten.

8a. Attach the Push Side Seat Assembly to the

Flywheel/Monorail Assembly using four of the

3/8" by 5/8" bolts and the top holes you didn't

use in Step 4b. Note orientation of the seat

assembly. If the holes don't align, lift the

monorail slightly.

8b. Firmly tighten all eight of the bolts at the connec-

tion between the Monorail and the Flywheel

Assembly. Also tighten the two bolts holding the

flywheel upright to the horizontal extension of

the Monorail.

9b. Roll the Carriage Assembly onto the Monorail as

shown. The fit should be snug and smooth.

Reinstall the End Stop in the same holes with

the rounded side facing the rollers.

Hint: You may also have to loosen the screws that

attach the seat to the Seat Brackets. If you do

this, be sure to tighten them back up.

9a. Prop the monorail up on something to keep it

horizontal for the next few steps. Remove the

End Stop on the bottom of the Monorail at the

end furthest from the flywheel. This part will be

reinstalled later.

10. Attach the Pull Side Foot to the Pull Side Leg

with two of the 3/8" by 5/8" bolts.

11/01