concept 2 DYNO Manuale di istruzioni per il montaggio - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Attrezzature per il fitness concept 2 DYNO. concept 2 DYNO 12.
8a. Attach the Push Side Seat Assembly to the
Flywheel/Monorail Assembly using four of the
3/8" by 5/8" bolts and the top holes you didn't
use in Step 4b. Note orientation of the seat
assembly. If the holes don't align, lift the
monorail slightly.
8b. Firmly tighten all eight of the bolts at the connec-
tion between the Monorail and the Flywheel
Assembly. Also tighten the two bolts holding the
flywheel upright to the horizontal extension of
the Monorail.
9b. Roll the Carriage Assembly onto the Monorail as
shown. The fit should be snug and smooth.
Reinstall the End Stop in the same holes with
the rounded side facing the rollers.
Hint: You may also have to loosen the screws that
attach the seat to the Seat Brackets. If you do
this, be sure to tighten them back up.
9a. Prop the monorail up on something to keep it
horizontal for the next few steps. Remove the
End Stop on the bottom of the Monorail at the
end furthest from the flywheel. This part will be
reinstalled later.
10. Attach the Pull Side Foot to the Pull Side Leg
with two of the 3/8" by 5/8" bolts.
4
11/01