DUCTFORMER TDFC Betriebs- und Verfahrenshandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Betriebs- und Verfahrenshandbuch für Industrielle Ausrüstung DUCTFORMER TDFC herunter. DUCTFORMER TDFC 12 Seiten. Power brake
Seite drucken7. Set-up of the Equipment
This system does not require any special flooring or grouting. The weight is evenly
distributed and there is a minimum amount of impact or shock load involved in the
operation. The area where the machine feet are located should be level and flat.
8. Wiring and Plumbing of the System
The electrical and pneumatic components have been pre-plumbed and wired for simple
installation. The Pneumatics and Electrical require (1) service drop each.
Electric:
110 Volt or 220 Volt single phase power (This machine is offered in either
110 Volt or 220 Volt versions)
Air:
5 CFM at 90 PSI
9. Controls and Control Functions
The controls consist of a variety of buttons, selector switches and a Micro Processor
Controller which all serve to control the functions of the machine.
NOTE: WHEN OPERATING ANY OF THE SELECTOR SWITCHES & PUSH
BUTTONS IT IS CRITICAL THAT THE OPERATOR FULLY UNDERSTAND THEIR
FUNCTION & VERIFIES THE MACHINE IS CLEAR FROM PERSONNEL OR ANY
OTHER HAZARDS.
OPERATING and PROCEDURES MANUAL
Page 7 of 12
TDFC POWER BRAKE