- ページ 7

産業機器 DUCTFORMER TDFCのPDF 操作および手順マニュアルをオンラインで閲覧またはダウンロードできます。DUCTFORMER TDFC 12 ページ。 Power brake

7. Set-up of the Equipment

This system does not require any special flooring or grouting. The weight is evenly

distributed and there is a minimum amount of impact or shock load involved in the

operation. The area where the machine feet are located should be level and flat.

8. Wiring and Plumbing of the System

The electrical and pneumatic components have been pre-plumbed and wired for simple

installation. The Pneumatics and Electrical require (1) service drop each.

Electric:

110 Volt or 220 Volt single phase power (This machine is offered in either

110 Volt or 220 Volt versions)

Air:

5 CFM at 90 PSI

9. Controls and Control Functions

The controls consist of a variety of buttons, selector switches and a Micro Processor

Controller which all serve to control the functions of the machine.

NOTE: WHEN OPERATING ANY OF THE SELECTOR SWITCHES & PUSH

BUTTONS IT IS CRITICAL THAT THE OPERATOR FULLY UNDERSTAND THEIR

FUNCTION & VERIFIES THE MACHINE IS CLEAR FROM PERSONNEL OR ANY

OTHER HAZARDS.

OPERATING and PROCEDURES MANUAL

Page 7 of 12

TDFC POWER BRAKE