Anywave PA-U-2200-D-FB Marble Schnellstart-Handbuch - Seite 15
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Transmitter Anywave PA-U-2200-D-FB Marble herunter. Anywave PA-U-2200-D-FB Marble 18 Seiten.
Seite drucken
Your TX should now be up and running properly into your load or on-air antenna.
Continue to monitor system parameters as you allow the transmitter to operate and
stabilize at full output power for another 30 minutes.
15) Navigate to the CAL setting under the AD3 Advanced submenu and select CAL
then press OK to calibrate the FWD PWR meter on the Exciter front panel to 100%.
16) To turn the TX On/Off, please use the RF On/OFF control in the RF submenu of
the exciter LCD or the exciter web interface. You may also use the TX ON/OFF
button on the PA's Home page, as shown below.
17) For Remote TX Monitoring and Control, you may network to the PA LAN RJ-45
rear panel connection at 192.168.1.200 – you can change the PA IP address by
navigating to the Config submenu on the PA's touchscreen, then pressing the
Network button, and changing the value of IP, or you can change it via the PA's Web
Interface. You may also network to the Exciter REMOTE RJ-45 rear panel
Mable 8Device Quick Start Guide, 5/19/2022
Marble 8Device Quick Start Guide
Page 15 of 18