Anywave PA-U-2200-D-FB Marble Manuale di avvio rapido - Pagina 15

Sfoglia online o scarica il pdf Manuale di avvio rapido per Trasmettitore Anywave PA-U-2200-D-FB Marble. Anywave PA-U-2200-D-FB Marble 18.

Your TX should now be up and running properly into your load or on-air antenna.

Continue to monitor system parameters as you allow the transmitter to operate and

stabilize at full output power for another 30 minutes.

15) Navigate to the CAL setting under the AD3 Advanced submenu and select CAL

then press OK to calibrate the FWD PWR meter on the Exciter front panel to 100%.

16) To turn the TX On/Off, please use the RF On/OFF control in the RF submenu of

the exciter LCD or the exciter web interface. You may also use the TX ON/OFF

button on the PA's Home page, as shown below.

17) For Remote TX Monitoring and Control, you may network to the PA LAN RJ-45

rear panel connection at 192.168.1.200 – you can change the PA IP address by

navigating to the Config submenu on the PA's touchscreen, then pressing the

Network button, and changing the value of IP, or you can change it via the PA's Web

Interface. You may also network to the Exciter REMOTE RJ-45 rear panel

Mable 8Device Quick Start Guide, 5/19/2022

Marble 8Device Quick Start Guide

Page 15 of 18