Airvolution Esatto ESL60D2S Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Lüftungshaube Airvolution Esatto ESL60D2S herunter. Airvolution Esatto ESL60D2S 19 Seiten. Slide-out rangehood 60 cm

Seite drucken

Installation height:

For optimum performance, it is recommended that the rangehood be installed at a height of

between 650-750mm from the cooking surface. See Fig. for detailed AS/NZS minimum distance

requirements.

Rear-mounting to the wall

• Using a spirit level, mark a horizontal line on the wall where the rangehood base will be, observing

all necessary clearances (Fig. ). Check the required clearances in your cooktop/stove manual and,

should they be greater than those specifi ed in Fig. , make sure to observe them.

Fig.

Minimum distance

– Electric:

– Gas:

Maximum distance

– Either:

Top of

cooktop

• Drill 4 holes of Ø8mm on the wall, as illustrated below (Fig. ).

• Hammer the wall plugs into the holes, then insert two ST4x30mm screws into the lower wall plugs.

Tighten the screws, but leave a 2mm gap so that you can hang the rangehood on the screws in the

keyhole slots.

• Hang the hood to the wall screws, and make sure the hood is in balance and positioned correctly.

• Take away the Aluminum Filters, mark and drill another 2 holes of Ø8mm on the wall . (Safety Screw

Holes)

• Take back the hood and hammer the wall plugs, hang the hood again and ﬁ x the hood with two

ST4x30mm screws.

WARNING: Failure to install the screws or ﬁ xing device in accordance with these instructions may

result in electrical hazards!

600mm

650mm

750mm

Rangehood base

Fig.