3rd Power CLEAN SINK MKII Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrumenten-Verstärker 3rd Power CLEAN SINK MKII herunter. 3rd Power CLEAN SINK MKII 12 Seiten.

Tube Layout:

CAN
V6
V5
V4
V3
V2
V1
CAPACITOR
POWER
TRANSFORMER
Tube Layout and Requirements:
V1: JJ ECC83S (Preamp, American and AC Voices)
V2: JJ ECC83S (Mix-down and Post EQ)
V3: Sovtek 12AX7LPS (Reverb)
V4: Sovtek 12AX7LPS (Phase Inverter)
V5 - V6: JJ 6V6S (Power Amp)
Bias Adjustment
Your CLEAN SINK MKII comes from the factory biased for JJ 6V6S tubes with an idle current draw of
~25ma. Bias adjustments are not intended to be user-serviceable. Attempting to adjust the bias your-
self will expose you to very dangerous high-voltage electricity that can kill you. Special test equip-
ment and knowledge of amp circuits and tubes are required to perform this function. DO NOT AT-
TEMPT TO DO THIS YOURSELF.
Tube Replacement
WE RECOMMEND TAKING YOUR AMPLIFIER TO A QUALIFIED TECHNICIAN FOR SERVICING YOUR
TUBES. Make certain the amplifier is turned off and has been allowed ample time to cool down. Be
very careful when you remove the tubes as they might still be very hot! Do not touch tube sockets
with fingers! Even after turning your amp off and unplugging it from the power outlet there could be
enough voltage stored in the capacitors to give you a lethal electrical shock.
WARNING:
• Do not remove the back panel.
• Do not attempt to check or replace tubes yourself. Refer to an authorized service center.
• Never touch the tubes while the amplifier is turned on or has recently been turned ON. You can
severely burn your fingers and hands.
9