3S TE200 Gebrauchsanweisung - Seite 15

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Medienkonverter 3S TE200 herunter. 3S TE200 20 Seiten.

Operation

4-1

The I/P Converter is shipped set to automatic operation.

To operate the transducer manually, use the following procedure to switch to manual operation.

(See Figure 4-1)

(The auto/manual switch is located on the left side of the I/P Converter unit.)

[1] Undo the screw and slide the protective plate so that the "M" becomes visible. Partially

retighten the screw in this position.

[2] Next, use a screwdriver to rotate the AM switch shaft as far as it will go in the direction of

the arrow on the plate (MANU direction).

[3] Adjust the reducing valve used to control the air supply to set the I/P Converter output

pressure. The output pressure is indicated on the output pressure gauge.

[1] To set back to AUTO, rotate the AM switch shaft as far as it will go in the AUTO direction.

[2] Slide the protective plate so that the "A" becomes visible again, then fasten in place.

Auto/Manual Switch

Figure 4-1

4－1