AOG L series Schnellstart-Handbuch

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Grill AOG L series herunter. AOG L series 2 Seiten. Stand alone outdoor gas grill
Auch für AOG L series: Schnellstart-Handbuch (2 seiten), Schnellstart-Handbuch (2 seiten)

Seite drucken

"L" Series

IMPORTANT: You must read the installation and owner's manual provided with the grill.

1-Safety

CAUTION: WHEN INSTALLING AND OPERATING THIS APPLIANCE,

YOUR OWNER'S MANUAL MUST BE OBSERVED.

OR EXPLOSION CAUSING PROPERTY DAMAGE, BODILY INJURY, OR DEATH.

This grill must be installed in accordance with local codes and ordinances, or, in the absence of local codes, with either the latest National Fuel Gas Code (ANSI

Z223.1/NFPA 54), and Natural Gas and Propane Storage and Handling Installation Code (CSA-B149.1).

This appliance and its individual shutoff valves must be disconnected from the gas-supply piping system when testing the system at pressures in excess of ½ psig.

This appliance must be isolated from the gas-supply piping system by closing its dedicated manual shutoff valve during any pressure testing of the gas-supply

system at pressures up to and including ½ psig.

This grill is designed for outdoor use only. DO NOT use this grill inside a building, garage, or enclosed area (see paragraph below). DO NOT use this grill

in or on a recreational vehicle or boat.

A minimum 5 foot clearance is required between the cooking surface and the overhead construction. When installed under combustible overhead construction,

the area above the cooking surface of the grill must be covered with an exhaust hood. The exhaust hood provides the protection for the combustible overhead

construction. DO NOT use this appliance under unprotected combustible overhead construction.When installed under overhead non-combustible construction,

an exhaust hood is highly recommended. When using an exhaust hood: the area above the cooking surface of the grill must be covered with a hood larger than

the cooking area of the grill, and with a minimum of 1200 CFM (cubic feet per minute) for proper outdoor application.

Installation must be performed by a qualified professional ser vice technician.

2-Unpacking

Carefully unpack the grill, removing all packing material and protective film (including the clear

film on the drip tray). Verify that all parts have arrived undamaged by consulting the parts list

in the owner's manual. Remove foam packed hardware from oven area. (See Fig. 2-1.)

Consult the parts list in the owner's manual. If any parts are missing or damaged, immediately

contact the AOG dealer before beginning installation.

3-Installation

Location

Locate the grill on a flat level surface. Refer to the INSTALLATION

REQUIREMENTS section of your grill owner's manual for complete details.

CAUTION: Wind blowing into or across the rear oven lid vent (Fig.

3-1) can cause poor performance and/or dangerous

overheating. Orient the grill so that the prevailing wind

blows toward the front of the grill (Fig. 3-2).

CAUTION:

To prevent dangerous overheating, the rear of the unit must have

a minimum clearance of 4" from any non-combustible wall.

Connect Gas supply

These quick start instructions assume a

propane cylinder configured unit.

main instructions for natural gas

or household propane configured

units.

Place approved propane 20 lb cylinder in tank

tray and secure in position (Fig. 3-3).

Connect quick coupler hose and regulator

supplied with unit to propane cylinder (Fig.

3-4).

Turn all burner control knobs to the OFF

position. Open the main cylinder valve. Then

carefully check all gas connections for leaks

with a brush and half-soap/half-water solution

before lighting. NEVER USE A MATCH OR

OPEN FLAME TO TEST FOR LEAKS.

Proper grill airflow must be maintained as

shown in Fig. 3-5.

REV 1 - 1804201015

Stand Alone Outdoor

Gas Grill Quick Start Guide

INSTALLER: Leave these instructions with consumer.

Sideburner

shelf (if

See

equipped)

Quick

coupler

Tank support sleeve

CONSUMER: Retain for future reference.

ALL INSTRUCTIONS AND WARNINGS IN

FAILURE TO DO SO MAY RESULT IN A FIRE

INCORRECT

Rear oven lid vent

YOU MUST PROTECT REAR OVEN

VENT FROM PREVAILING WIND

Fig. 3-1

Backburner

(if equipped)

Propane

cylinder (tank)

Fig. 3-3

Lift out foam packed hardware

Fig. 2-1

CORRECT

PLACE GRILL SO PREVAILING WIND

BLOWS TOWARD FRONT OF GRILL

Fig. 3-2

Brass Acme

Regulator

thread fitting

Liquid level

Vent

indicator

Hand nut with

Hose

(optional)

Acme thread

Fig. 3-4 Type I Acme thread quick coupler

To connect the regulator/

hose assembly to the

propane-gas cylinder

valve fitting: Press the

hand nut on the regulator

over the Acme thread fitting

on the cylinder valve. Turn

the hand nut clockwise to

Maintain proper

engage the threads and

ventilation airflow

tighten until snug.

Fig. 3-5

Remove plastic

zip-ties

Hand wheel

QCC

Type 1

valve

Pressure

relief

valve

L-C2-482