AOG L series Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Grill AOG L series herunter. AOG L series 2 Seiten. Stand alone outdoor gas grill
Auch für AOG L series: Schnellstart-Handbuch (2 seiten), Schnellstart-Handbuch (2 seiten)

Seite drucken

4-Grill Setup

Parts Placement Checklist

Place the following items according to their position and orientation

in Fig. 4-1:

Vaporizer panels, cooking grids, and warming rack.

Leave pre-installed burners in place to maintain proper alignment.

Vaporizer Panels

Place the vaporizer panels directly onto the studs on the burners. The

panels allow heat from the burners to be evenly directly throughout

the cooking area.

Cooking Grids

Place the cooking grids (over the burners) onto the grid frame.

Warming Rack

The warming rack comes pre-installed. Remove zip ties before use.

Consult the owner's manual to remove or replace.

Shelf/Sideburner (if equipped)

Align the four (4) holes in the shelf with the four (4) holes in the side

of the cart while aligning and engaging the burner venturi with the

orifice (Fig. 4-2). Insert the four (4) screws (provided) into the holes and

tighten. Make the igniter wire connection as shown in Fig. 4-2. Open

sideburner lid, set cap on burner, and set grid into shelf.

IMPORTANT: See your grill owner's manual for complete installation

details.

Connect

Screws

Venturi

Fig. 4-2

Read setting here

Read setting

(OFF position shown)

here

OFF

Gas Flow

Indicator

Press

knob in

to turn

Fig. 5-1 - Burner valve control knob

For your convenience and safety;

when the control knob is turned to

the ON position, the gas flow indicator

will change from blue to red. (Red

indicates gas flow.) See Fig. 5-1.

WHEN OPERATING THIS

GAS APPLIANCE, ALL

INSTRUCTIONS AND

WARNINGS MUST BE

OBSERVED. FAILURE TO DO

SO MAY RESULT IN A FIRE

OR EXPLOSION CAUSING

PROPERTY DAMAGE, BODILY

INJURY, OR DEATH.

‡

The light switch is push button operated,

and is located on the right side of the

control panel (see Fig. 5-2). It controls

the power to all lights.

Propane

and Natural Gas Safety

IMPORTANT: READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.

READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND

IN YOUR OWNER'S MANUAL. FOR NATURAL GAS READ ALL SAFETY INSTRUCTIONS AND WARNINGS

FOUND IN YOUR OWNER'S MANUAL.

7-Routine Maintenance

Your grill must be serviced and maintained properly to ensure optimal performance, appearance, and safety. The grill must be cleaned

as often as twice a month (depending on use) to prevent grease build-up and other food deposits. See owner's manual for details.

REV 1 - 1804201015

Igniter wire

Air shutter

Replacement parts can

be ordered from your

local AOG dealer.

Orifice

5-Test

Note:

Grill must be connected to 120VAC power for electronic lighting.

1. Open lid(s) or remove cover(s) from burner(s) to be lit.

2. Turn all gas control knob(s) to their OFF position(s).

3. Turn on the gas at its source.

Use

HIGH to

LIGHT

HI (high)

to light

Note: DO NOT turn on more than one valve at a time for either electronic or manual lighting.

Depress the control knob for the burner to be lit and turn it to the HI LIGHT position, then

press the ignition button. Once the burner lights, release the ignition button.

CAUTION:

5. Repeat step 4 for each additional burner to be lit.

Ignition

switch

Sideburner

control knob

(if equipped)

Cooking Grid

Vaporizer panel

(not with IR)

Warming

rack

Sideburner shelf

(if equipped)

Ignition

switch

Drip tray

Fig. 4-1

If a burner does not light within five (5) seconds of turning on the control

knob, depress the knob and turn it to the OFF position.

MINUTES before repeating step 4. If you smell gas, follow the instructions on

the cover of the grill owner's manual. If the burners still do not light after several

attempts, refer to the grill owner's manual for manual lighting.

Center main burner

control knob

Left

Drip

main burner

tray

control knob

and 36

model controls

Note: For infrared burner (IR) equipped

grills; see detailed instructions

included in your owner's manual.

The burner

ports and carry-

over ports must

be kept clean to

Main

ensure proper

burner*

ignition and

operation.

Backburner

(if equipped)

Grill lights

(not shown)

Rotisserie kit

(if equipped)

Power

supply

Light

switch

WAIT FIVE (5)

Right

main burner

Backburner

control knob

(if equipped)

Control panel

screw(s)

Light

‡

switch

Fig. 5-2

L-C2-482