aevit VIC 2.0 Handbuch für Installation und Betrieb - Seite 15

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Kontrolleinheit aevit VIC 2.0 herunter. aevit VIC 2.0 17 Seiten. Voice interactive controls

Seite drucken

VIC 2.0 OperATION

OperATION STep 2 (CONT'd)

The START/STOP Confirmation Functions are a bit different than the shifting functions. In order to

START the engine, the client must first physically wake the system up by pressing the "Wake-Up" but-

ton. Then, the client can prompt VIC 2.0 to START the vehicle. For example, to START the vehicle:

Press the Wake-Up Switch

Press the Listen Switch:

BEEP

(wait one second)

Client: "Start"

VIC 2.0: "Please confirm, start"

Client: "Start"

VIC 2.0: "Start recognized"

The AEVIT 2.0 system will then turn the ignition on and start the vehicle's engine.

The STOP function turns off the vehicle's ignition. The client will still have to manually boot the sys-

tem down after using the STOP command.

THESE COMMAND CONFIRMATIONS ARE ADDED SAFETY FEATURES OF VIC 2.0 TO PREVENT THE

OperATION STep 3

If you have a AEVIT Steering System, VIC 2.0 will walk you through re-engaging the Steering Servo-

motor once it has been dis-engaged. To test this, manually disengage the Steering Servomotor as

described in the Operation and Programming Manual and boot down the system. When the system

is booted up VIC 2.0 will walk you through the steps for re-engaging the Steering Servomotor.

OperATION STep 4

Besides engaging the Steering Servomotor, VIC 2.0 has other verbal feedback when the client is

operating the AEVIT 2.0 system. Most notably, when the client boots the system up, VIC 2.0 gives

feedback on the AEVIT 2.0 system's boot-up procedure such as:

-Notifying the client of when to disable the controls

-Providing explanation on the AEVIT Backup Self Tests

-Verifying control of the input devices

When the client boots down the system, VIC 2.0 will provide feedback such as:

-Notifying the client of the detected loss of ignition

-Details on shutting down the system

CLIENT FROM ACCIDENTLY ExECUTING A CRITICAL FUNCTION.

NOTE:

5-2

VIC 2.0 INSTALL MANUAL