Cassida C 200 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Geldzähler & Münzsortierer Cassida C 200 herunter. Cassida C 200 11 Seiten. Coin counter/sorter/wrapper
Auch für Cassida C 200: Benutzerhandbuch (20 seiten)

Seite drucken

Repeat procedure to set the desired batch quantities for other coin denominations.

The C200 will stop when a desired batch quantity is completed for any of the

denominations. The denomination will be displayed on the left and the total count for that

denomination will be displayed on the right side of the screen.

NOTE:

When operating in batch mode, the C200 will keep a running total for

each denomination coin. For example, after four batches of 50 fils have

been dispensed, the C200 will stop and display:

To resume counting, press "START/STOP" button.

Pressing the "C" button will reset the count and the machine will start batching from zero.

The batch quantities you choose will be stored in the C200's internal memory, and will not

be reset when the machine is turned off.

2.5 Clearing Batch Quantities

You may clear batch quantities for each denomination by pressing "BATCH" button until

C200 displays " " message on the control panel.

MAINTENANCE AND TROUBLESHOOTING

3.1 Maintenance

Most operational problems can be avoided by regular care and preventative maintenance.

Taking regular care of your coin sorter will significantly increase its lifetime and help you

avoid costly repairs.

IMPORTANT: You should always turn the machine off and

disconnect the power cord before cleaning the machine.

To get the best results out of your machine, the following maintenance is recommended on

a regular basis:

Clean all external parts of the machine with a Cassida air duster or a soft cloth. Do not

use solvents, as they may damage the C200.

Clean all the sensors using the procedure described below.

1. Remove the three housing screws and carefully lift up the housing.

2. Clean all sensors and other dusty parts using a Cassida air duster followed by a CleanPro

swab. See Figure 6 for sensor locations.

3. Replace the housing. The housing must be properly lined up with the AC power cord at

the back of the machine. Do not force the housing into place, as this could damage the coin

feed mechanism built into the housing.

Cassida C200 coin counter/sorter/wrapper