Aeware in.zone Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Spa-Zubehör Aeware in.zone herunter. Aeware in.zone 14 Seiten. Innovative corona discharge ozonator
warnings
Warnings!
Important safety instructions
• Read and follow this manual carefully and make sure to save it
for later.
• This manual contains important information on in.zone's
installation, use and safety recommendations. It is your
responsibility to install and use your in.zone safely.
• Do not use in.zone if it is not connected to the spa system
(venturi) ; do not directly inhale ozone coming from in.zone.
Ozone can cause serious problems to your health.
• Do not install in.zone outside of the spa equipment
compartment; it should be installed behind the spa skirt or panel
and protected against rain, sun, water hose or sprinkler, snow
and other outside elements.
• Install in.zone above water level or as high as possible (as close
to water level as possible). Also install a check valve and make an
Hartford loop.
• In.zone must be installed out of the bather's reach.
• Make sure no water can get inside in.zone's enclosure. A check-
valve must be installed between the injection point and in.zone.
• Make sure a suffi cient vacuum allows ozone to be injected
in water.
2
• If in.zone is used indoors, it must be in a ventilated room.
• Follow all electrical codes required for this type of installation
and make sure all electrical connections are made by a qualifi ed
electrician.
• Use only electrical cord in good condition to power in.zone.
• In.zone must be connected to a circuit protected by a ground
fault interrupter (GFCI).
• Make sure all electrical power is off before installing or servicing
in.zone.
• If in.zone electrical connections are going through the spa system
control, it is important that this control be protected by a GFCI.
• In.zone should be activated only when a pump creates a
suffi cient air vacuum.
• Never service an in.zone if you are wet.
• Do not open the unit; there is no serviceable parts inside.
• Disposal of the product: the in.zone must be disposed of
separately in accordance with the local waste disposal legislation
in force.
in.zone