Aeware in.zone Руководство - Страница 3

Просмотреть онлайн или скачать pdf Руководство для Аксессуары для спа Aeware in.zone. Aeware in.zone 14 страниц. Innovative corona discharge ozonator

Warnings!

Important safety instructions

• Read and follow this manual carefully and make sure to save it

for later.

• This manual contains important information on in.zone's

installation, use and safety recommendations. It is your

responsibility to install and use your in.zone safely.

• Do not use in.zone if it is not connected to the spa system

(venturi) ; do not directly inhale ozone coming from in.zone.

Ozone can cause serious problems to your health.

• Do not install in.zone outside of the spa equipment

compartment; it should be installed behind the spa skirt or panel

and protected against rain, sun, water hose or sprinkler, snow

and other outside elements.

• Install in.zone above water level or as high as possible (as close

to water level as possible). Also install a check valve and make an

Hartford loop.

• In.zone must be installed out of the bather's reach.

• Make sure no water can get inside in.zone's enclosure. A check-

valve must be installed between the injection point and in.zone.

• Make sure a sufﬁ cient vacuum allows ozone to be injected

in water.

• If in.zone is used indoors, it must be in a ventilated room.

• Follow all electrical codes required for this type of installation

and make sure all electrical connections are made by a qualiﬁ ed

electrician.

• Use only electrical cord in good condition to power in.zone.

• In.zone must be connected to a circuit protected by a ground

fault interrupter (GFCI).

• Make sure all electrical power is off before installing or servicing

in.zone.

• If in.zone electrical connections are going through the spa system

control, it is important that this control be protected by a GFCI.

• In.zone should be activated only when a pump creates a

sufﬁ cient air vacuum.

• Never service an in.zone if you are wet.

• Do not open the unit; there is no serviceable parts inside.

• Disposal of the product: the in.zone must be disposed of

separately in accordance with the local waste disposal legislation

in force.

in.zone