Aeware in.zone Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch für Spa-Zubehör Aeware in.zone herunter. Aeware in.zone 14 Seiten. Innovative corona discharge ozonator
Seite druckenin.zone
Installation schemes
The following material is recommended:
Two (2) # 10 screws of appropriate length with round, truss or pan
head and two (2) washers 1/2 OD x 1/16" thickness.
To install in.zone:
Select the most appropriate location on the fl oor or the wall
(recommended) and fi rmly attach in.zone to a wooden base with
(2) screws backed by (2) washers.
Note: If you choose to install in.zone on the fl oor or close to the
fl oor (not recommanded), it must be installed at least 4" above
it
it must be installed at least 4" above
potential fl ood level. If fl oor is on ground level, in.zone should be
raised at least 4".
Warnings and important notes
Important: Please note that countersunk screws should not be
used as they can damage in.zone base.
Attention: In.zone air intake should not be pointing up; it
should either point down or to the side to prevent water
infi ltration.
Warning: Beware of some products commonly used against
corrosion (such as WD-40 family products). Their use, due to
negative chemical reactions between some industrial oils and
4" 4"
plastic, could damage in.zone's plastic enclosure. Any other
materials which may come in contact with its enclosure must be
carefully evaluated for compatibility.
air intake
air intake points
points to
to the ground
the side
installation
air intake
points up
7