Duratool D01965 Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Duratool D01965 herunter. Duratool D01965 12 Seiten. 18v li-ion cordless drill driver

Seite drucken

1. Charging the Battery

Press the on/o button (1). You can regulate the machine's rpm by the

pressure applied to the switch.

Once the switch (1) is released, the drill chuck stops and rotation ceases.

Push the rotation direction switch (2) into the centre to lock the machine

when it is switched o . Do not put the machine down until the motor has

stopped completely. Do not put the machine on a dusty surface. Dust can

penetrate the mechanical parts.

Charging the Battery

The battery pack has been shipped in a low charge condition to prevent any possible

(drilling until the battery has no more power followed by recharging) for the item to

fully charge.

Allow the battery to cool down in between use and charging!

The battery pack will become slightly warm to the touch while charging, this is normal

and does not indicate a problem.

Do not place the charger in an area of extreme heat or cold, it will best at normal room

t emperature. When the battery becomes fully charged, unplug your charger from the power

supply and remove the battery pack from the charger.

The normal charging time after the initial 4-5 charges should take about 1 hour. (this may

Charging Process:

1-With the battery Not Inserted, plug the charger into the mains socket. The Green light will

i lluminate

2-Insert the battery pack into the charger until the button on the battery pack clicks into

place（Ensuring not to force it）.The Green light will stay

3-When the battery is fully charged the Red light changes to permanently on, the green

light stays on

4-When the Red light is showing permanently. The battery should be removed and the

charger disconnected from the mains supply.

IMPORTANT! Never leave the battery on charge for more than 2 hours！

the battery