Duratuf MK4A Montageanleitung Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Lagerung im Freien Duratuf MK4A herunter. Duratuf MK4A 16 Seiten. Kiwi series, base size 4.210mm x 2545mm

Seite drucken

MK4A CLEAR ROOF PANEL (Optional)

Step 1: Leave a gap where the Clear Panel is to be fitted. Position the next Roof Sheet. Ensure it overlaps correctly, then

rivet together, one rivet in the centre and one approximately 600 mm down from the centre on both sides. Rit re-

maining Roof Sheets, overlapping and riveting as you go. Nail on first Roof Sheet (refer step 3 on page 10).

Step 2: Where the Clear Roof Panel is to be positioned, nail a 45x45mm Bevelled Edge Support on each side of the

Ridge Beam. (fig. 1)

Step 3: Position Clear Roof Panel and Flat Roof Sheet (or second Clear Panel). The Flat Roof Sheet underlaps one sheet

and overlaps the other. The Clear Roof Panel OVERLAPS both Roof Sheets. Ensure sheet joins are flush at the

outside edge then rivet flat sheets to pressed sheets, three rivets per join. Centralise Roof at the other end and

nail in place.

Step 4: Ensure Ridge Beam is straight, then nail the Clear Panel and Flat Roof Sheet (or second Clear Panel) to

45x45mm Bevelled Edge Supports using one 30mm Clout per Pan. Run two generous beads of Silicone on the

under side of the Pressed Capping Sheet. Position Pressed Capping Sheet on Ridge Beam and nail in place us-

ing three 40mm Weatherseals. Nail one 40mm Weatherseal into Ridge Beam beside each overlap (one nail per

sheet).

Step 5: At the Back set up a String line in the centre of the Top Plate. Ensure Top Plate is straight and nail off, one 40mm

Weatherseal per Pan. Repeat at the front.

Note:

When nailing through the Clear Panel, pre-drill a 6mm hole.

Note:

Diagram shows MK2 model